Car clutch maintenance method

1. Since the release bearing has been exposed for a long time the lubrication conditions are poor, after every 300 to 500 hours of tractor work, the release bearing should be removed cleaned with diesel oil to make it rotate flexibly. Then put it into a container filled with butter heat it until the butter is full of the bearing. After it has cooled solidified, take it out install it.

2. The separation claw the spiral slope of the bearing cover should be cleaned frequently lubricated with oil butter, the small oil hole on the separation claw should be often dripped with oil to lubricate the separation claw the separation claw seat.

3. When the friction plate, active plate pressure plate in the clutch are stained with oil rust, they should be disassembled to remove the oil oil, cleaned with gasoline kerosene, installed after drying.

4. After cleaning replacing the clutch bearing, apply an appropriate amount of butter, make the side with the dust cover face the clutch, do install it backwards to prevent oil flowing into the clutch causing the clutch to slip.

5. Regularly adjust the operating mechanism of the clutch, remove the soil, tighten all connecting bolts, lubricate the clutch pedal shaft as required.

6. If it is found that the friction plate exposes the rivet head, cracks, breaks, large-area scorching, each friction plate wears to a thickness of less than 3.4 mm, a new friction plate should be replaced.